The Difference Between a Manual and Electronic Stud Finder

A stud finder is a handheld electronic device used to find framing joists located just behind the wall covering material, generally drywall. While there are several different stud finders on the market, most fall into only two basic categories: manual or electronic.

Franklin Sensors operate by pulling a wire across the wall, using metal or steel rods that hook on to each other. When a stud is located, a tiny coil activates the wire. Once triggered, the coil sends out an electrical current to the stud's corresponding holes in the drywall and ceiling. This electrical current is sent through to a monitor screen that monitors where the stud is located. Once the current is found, a sound alerts the operator that the stud is located, and it's possible to then do an inspection.

Magnetic stud locators are similar, except for the fact that they require the use of magnets to activate the coils. The use of magnets is often a better choice than wires, as wires can sometimes be knocked loose or misplaced during use, and are not always protected from electrostatic shock. While they also provide similar visual inspections, magnetic stud finders are often more useful for their ability to pinpoint the exact location of studs.

With the use of a stud finder, both manual and electronic, the installer can perform an initial inspection of your drywall and ceiling before undertaking any kind of electrical installation. It's vital that you take care to inspect the drywall and ceiling for loose boards, cracks, and other potential problems before beginning your work, especially if this is your first electrical job. In addition, it's important to make sure that the electrical wiring is secure. If a connection or wire becomes loose, you could potentially damage your ceiling or drywall or both. You can now find those studs on this page.

The presence of studs and the location of the drywall and ceiling will determine the appropriate type of stud finder to be used. Manual stud finder detectors are generally larger and more powerful than the electrical stud finder models. They usually have a metal rod that is buried inside the wall. And while this type of detector may cost more than an electrical model that uses electricity, the increased power and range afforded by the latter will definitely pay off in the long run. In more accurate stud locate results. And as with any electrical installation, it is absolutely essential to keep the location of the studs and electrical wiring secure when starting any kind of work, so don't begin your installation until you've consulted a professional to get an understanding of the project.

Both types of stud finders are equally effective, but electrical will typically be your best bet if you plan on doing a large amount of electrical work in a confined space. However, they are usually more convenient and easy to use compared to manual models. In addition, it is important to make certain that you have an expert to inspect the work area to ensure that nothing needs replacing, and that the work area is clear and free of debris. Remember, your safety is of utmost importance when you are handling electrical items, especially those that have the potential to cause serious injury. If you probably want to get more enlightened on this topic, then click on this related post: https://www.ehow.com/how_7553004_use-zircon-studsensor.html.